At a Glance

Name of machinery
A Screw press 60 MT 4 Nos
B Power Press 80 MT 2 Nos
C Power Press 60 MT 3 Nos
D Lathe 8 FT 2 Nos
E shaper 6 FT 2 Nos
F Tooling 60 MT 6 Nos
G Landies 2.5 INCH 3 Nos
H Hand Grinder 8 INCH 4 Nos
I Bench Grinder 12 INCH 4 Nos
J Drill 1/2 INCH 2 Nos
K Drill 1 INCH 1 No
L Coal Furnish 8 FT 4 Nos
M Blower 18 INCH 4 Nos
N Vice Bench 10 INCH 6 Nos
O Bending Bench 20 MM 1 No


Name of Euipments Qty Calibration validity
A VERNIER 2 Nos 17.08.2010
B STEEL TAPE 2 Nos 17.08.2010
C IN-SIDE GUAGE 6 Nos 22.09.2010
UAGE OUT-SIDE GUAGE 6 Nos 22.09.2010
E SCREW GUAGE 2 Nos 23.02.2011
F MICROMETER 1 No 23.02.2011
G WEIGHING SCALE 1 No 23.02.2011
H HYDROMETER 1 No 23.02.2011
I STEEL SCALE 2 Nos 23.02.2011

List of Product
A Pin for insulator 1.1 KV TO 33 KV (As per IS: 7935 & IS : 2486)
B Stay sets L.T & H.T (AS PER SPECIFICATION) (BS-16)
C Earthing Set Rod Type, Pipe Type & Coil Type (As per IS:2062, IS:1239 & IS: 280)
D String Hardware T & C, B & S (As per IS:2486)
E PVC Line Spacer 1 Ph 2 Wire, 3 Ph 4 Wires (As per REC)
F Danger Board L.T & H.T (As per IS: 2551)
G Connector P.G Clamp, U.D.C, (As per IS: 5561)
H Jointing sleeves Pipe Type, Spiral Type (As per IS:12048)
I Suspension Clamp L.T & H.T ABC (As per IS:2486)
J Dead-End-Clamp L.T & H.T ABC (As per IS:2486)
K Piercing Connector L.T & H.T
L Shackle Hardware As per IS: 7935
M D-Iron Clamp As per IS: 7935
N Eye Hook As per requirement
O BPL-KIT As per NHPC,NTPC,DVC, and WBSEDCL Specification.
P Conduct pipes (HDG) As per IS:1239
Q Bolts & Nuts As per IS:1363,IS:1364
R Fabricated Structural As per:2062,IS:808

Up To 33 KV Line



c.Line structure.


ANINDITA ENGINEERING All Rights Reserved.(Terms of Use)
Developed and Managed by Infocom Network Ltd.(Terms of Use)
Developed and Managed by Infocom Network Ltd.